Skip to content
Contact

Cord

15Topics

Cord forum

Wiring at cross shaft issue

Out for a drive today and got stuck in gear, on inspection found this wire off. Question is,, can I undo the four screws without bits all falling out and rerpair it ? Hopefully as it's off for a new exhaust to be fabricated next weekend !

Last reply by mailtrevorcowell.co.uk

Cord oil leakage problem

Recently while on tour I had some performance problems and tried to fix that problem, but ended up with more problems. The repair turned into a oil leakage problem. Here is a summary of events. Any suggestions would be great because I am mi

Last reply by Terry Cockerell

Dual brake master cylinder / Clutch switch.

With my renewed enthusiasm I want to get a couple of bits done on my list. Dual circuit brake cylinder ,I found this one Ebay item 117045146057. If suitable I will order, open to other suggestions, I can fabricate the pipes no problem. I th

Last reply by mailtrevorcowell.co.uk

Broken gear selector lever

I got the car out of it's Carcoon and into the yard and was greeted with a box of neutrals, fearing the worst we remove the front cover and was greeted with this snapped lever ! I was able to weld it on there and then. Looking at it it's a

Last reply by Terry Cockerell

'36 Phaeton Convertible Top Parts

I need to replace these two broken parts on my '36 Phaeton. The windshield clamp goes on the driver side, and the long piece on the passenger side. Please advise, and thanks. James Bartlett jamesandeileen@comcast.net 832-606-7599

1 / 2
Last reply by Terry Cockerell

New 810-812 Cord front Bendix brakes

I have been working on NEW Bendix self energizing brake assemblies with self adjusting mechanism. I purchased a number of modern parts and began the process of figuring how to make them work with Cord hub bolt pattern and offset. And yes, I

1 / 2
Last reply by Terry Cockerell

Ball Joint - replacements

I need to replace one of trhe ball joints on the "V" shaped steering arm on my 810 Cord. Can anybody tell me what is compatible from other vehicles? Or where I can obtain a suitable replacement?

Last reply by Terry Cockerell

Headlight assemblies

I am in need of a set of headlight assemblies to finish a Cord for my son Ben. Let me know if anyone knows of these. I have the cables. Pat Leahy

Last reply by Barrie Hutchinson

Bendix brakes

I recently consulted with a brake system specialist to procure new brake shoes, wheel cylinders, and all hardware and springs. He supplied me with a self adjusting modern mechanism also. Is there anyone else who needs these items? I can pro

Last reply by 37beverly

Cord front hubs

Today while cleaning some parts to use on my son's 1937 Beverly, i found I have three different hub thicknesses. I always thought early cars had light hubs and later had heavy type. The picture below shows the three sizes, .11", .25", and .

Last reply by Terry Cockerell