It is a press fit. leave the washer off. either use the bolt you took out or another of the same thread, screw it in all the way . drive it out.
it only fits one way putting back( pay attention) when the tensioner is replaced with the timing chain on. hand turn it until the chain is tight. carefully install the spring tension. wind it up most of the way.
Thanks guys,
I did finally get it out. I used a trick that helps loosen stubborn joints to ease its removal. 50% transmission fluid and 50% acetone 24 hours before removal and I was able to remove it without using too much force. Try this mixture, it really works good on frozen rusty bolts and nuts. In this case I was dealing with years of varnish build up which it dissolves easily. The acetone helps it penetrate into impossible areas while the high detergent oil loosens rust and varnish build up. I have removed nuts, which are caked with rust, with an end wrench after a few days of soaking with this concoction. Try it. It really works.
Thanks, Curt
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
