Hi Woody, Congratulations on your "New" Cord!!! If you haven't already make sure you join the ACD Club. Hopefully we'll see you and your Cord at one of our meets.
 
For the transmission use a 90-140 gear oil that is safe for yellow metal. I recommend Lubriplate SPO-277. It works very well in the transmission. You need to drain both point on the trans, the differential and the gearbox. Always filter the oil as you drain it to check for metal and balls. There is only one fill point on the top, left side. The capacity is 5 quarts. You can check the level by using the engine dip stick in the transmission fill port, just pull the pipe plug and slide the dip stick down past the shift rails.
 
For the engine use a 30wt non-detergent oil. The capacity is 7 qts. I put 6 qts in and check the level to make sure before adding the 7th.
 
The Cord did not originally have a rear view mirror on the drivers side, only on the center of the dash. Lots of owners have installed aftermarket mirrors. Just watch out what mirror you get, it has to stick out from the body fairly far to be able to see behind the car. Many of the mirrors I've seen are looking at the lane next to you.
 
Jim
Hello Woody, as Jim suggested you should join the ACD Club. I have come up with a design to attach side mirrors to convertible Cords and this will be published in the newsletter in the not too distant future.
Regards
Terry Cockerell
Australia
Jim,
 
Thank you for the answer regarding my 37 Cord. You mentioned using non detergent oil in the engine. Would it be a good idea to add some zinc with that 30 weight oil?
Woody
Hi Woody, I don't use a zinc additive and I haven't had a problem. I do know some people who's opinion I respect, that swear by the zinc additives. So the bottom line is I don't have a good answer for you.
Jim
Use Valvoline VR 1 if you want Zinc.
CORDially MIke
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
