I don't have a phaeton but do have some copies of Factory drawings that were taken over by the Hupmobile Company.Attached is a drawing of the latch which appears to be identical to yours.
The latch is correct but there is a larger brass plate to which it attaches.
T
· Jan 19, 2023
This is probably the brass plate referred to.
 
Sorry the file will not open when I attach it.
 
 
 
 
 
 
T
· Jan 19, 2023
Here is a picture of the mounting plate installed in my top frame. If you need details or measurements I can remove it.
Tom 
T
· Jan 19, 2023
Tom that is the part I have a Factory drawing of. I can try taking a photograph of the picture then uploading it to the Forum.
T
· Jan 19, 2023
Here is a picture of my whole assembly, latch plus brass plate. My brass plate is not inset into the header, but it is a 1937. Plate measures 5 x 1 3/4 x 1/4 inch.
W
· Feb 6, 2023
I have a later 1937 phaeton which has the original header and all the latch backing plates are indented exactly the same as in the 1936 models.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.