Are you referring to the large cylinder on top of the transmission or the rectangle looking piece on the passenger side not functioning correctly? Either way each piece has kits or parts available to rebuild them. But before throwing parts at a problem you need to "find" the problem area. The transmission shifts by vacuum, mechanical and by electrical means.. On the steering column shifter is a ten wire harness and it has 100 connections that can fail. The main electrical plug has 40 electrical connections.. On the very front of the transmission on the passenger side is what's called the cross shift diaphragm. That may be a problem too. All your problems might be just a bad electrical connection too. My best suggestion is tell this forum what state you are located in so someone might be close by to help diagnose the issues.
 
 
Gary Parsons
Hi Amber,
Glad to hear you have the Cord running well. As Gary said are you sure the main shift cylinder is what is going you the problem? Before tearing into the main shift cylinder do a quick check to make sure you are getting good vacuum to the cylinder - you should have at least 15"Hg. Anything less then that you need to start tracing back to see where you are losing the vacuum. 
 
Second question would be is the problem with the piston moving forward or backward? If the problem is both directions I would go back to the vacuum first. If it is just forward I would check the shaft seals and the switch seals.
 
To answer your question there are no kits available but the parts are usually available locally. If you want I can email you a copy of an article I wrote for the Newsletter a few years ago on how to rebuild and set up the mail shift cylinder.
 
Jim
Jim.
 
Thanks for the quick response back. If you could send me the newsletter article, that would be great. My email is amberbrenzikofer@gmail.com.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
