Hi Paul,
You have to remove the cotter pin on the castle nut and remove the nut. Remove the washer and the outer bearing. The drum should now come off. You can pry gently between the drum and the backing plate. If it is really stuck get a puller that uses the lug bolts to bolt to the drum and pushes on the axle. These pullers can apply a lot of pressure to pull the drum.
Jim
Jim is exactly correct. These rear drums require much more work to remove than what is normally found on other cars. Once you have done this job it's really simple the next time. My guess is the wheel cylinder has leaked and the shoe lining has gotten wet and sticky. The original lining was riveted asbestos lining and no longer used because of the hazards. I suggest you reline both sides so you have the same stopping power on both sides. Otherwise you may find the car might pull to the old lining side. If you're in California I can recommend a shop that can reline the shoes but it will be bonded. Not riveted lining and won't be Asbestos either.
 
 
Gary Parsons
The brake drums are riveted to the wheel hubs.
A guy who restored a RHD Westchester in Sydney during the 1990s has recently discovered that a bonded lining has separated.
You are never far from the spanners.
When you use the puller Jim is talking about be prepared for the drum to "Pop Off" in a dramatic and sudden explosion that you don't want hitting your foot or any other part of your anatomy!!
CORDially Mike
I had a similar situation, it turned out the single brake return spring was broken and the shoe jambed the drum. Rocking the car back and forth oon the floor finally got it to break loose.
Scott
Thanks to all for the help on this. The jam was caused by a broken return spring that jammed between the shoe and the drum. Just like HDVETTE said. It took a little persuasion and several colorful adjectives, but it finally let loose. Suprisingly little damage to drum or shoe, just to the lining. Thanks again everyone for your help.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
