It is not a 5 minute job. Raise the bonnet and tie it up to the roof or prop it off the engine with a stick. Drain the cooling system, remove the distributor, carburetor, generator and exhaust manifolds then the inlet manifold to gain access to the tappets. It would be a good idea to remove the wrap around grill too.
The recommended settings for the tappets is 0.008" however I believe the exhaust valves should have more clearance and be set at 0.010"
Well that will get you started. I'm sure others will add to this.
If the engine has not had an upgrade to the rocker arm rollers, the adjustment might not help.
too much roller  and pin wear make adjusting a temporary fix.
From you email address I see you are in New Zealand.
Do you know Graham Gibson?
hi Terry,
No I don't sorry. When I have done tappets on other cars, you can turn crank over with a socket on crankshaft, what's the easiest way to turn engine over? Looks like a few tricks I need to learn.Paul
Graham has the black RHD Westchester.
I will pass your email address to him.
 
You can turn the flywheel with a screw driver through the timing mark window in the bell housing. Remove all spark plugs first.
I made a tool to pull on the ring rear from below the car.
I will post some pictures tomorrow.
 
I'm in Australia located between Sydney and Newcastle.
Hi All, just getting to this job now. Could I have car in 4th gear, plugs out, one wheel on ground and use the other wheel to turn over engine? When I take distributer out does it have one location it slots back into , or is it a gear and can go in many locations
The distributor drive has a one way fit design. It's not meshed by a gear. The drive has an offset that only allows the installation to fit one way. When you remove it look at the bottom drive. Hopefully the adjustment works but all previously stated if the rocker arms have not been upgraded to the roller needle bearings this adjustment may end up a temp fix. It's a big job to adjust lifters but... It could be a lifter adjustment on a Duesenberg J engine. Those are double overhead cams and it's a 40 hour job...
Gary Parsons
You could try turning the engine via the wheel, but I recommend using a lever or screw driver through the window in the bell housing. You will have more control over the crankshaft movement. I suggest you purchase a copy of the 810 812 Cord Service Manual from the Museum in Auburn
Unscrew the exhaust manifold gland nuts. This requires a hooked spanner.
Loosen exhaust pipe bracket below engine, then remove exhaust manifolds.
Remove thermostat housing covers and plumbing up to radiator.
Remove distributor which has an off center key which can only be fitted one way.
Remove carburetor and linkages
Remove vacuum lines to manifold at T fitting
Remove generator.
Inlet manifold may now be unbolted and removed.
The Service Manual says set all tappets at 0.008", I feel this is an error and have discussed the issue with various Cord specialists. All other engine I have worked on have a wider exhaust clearance. Consequently use 0.008" for the inlet valves and 0.010" for the exhaust valves.
Working over the front fenders is tedious make sure you cover them with blankets, sleeping bags etc.
Good luck ....................... allow at least three days and don't drop anything into the rocker arm area as it will end up straight down into the sump.
Finally done,jeepers not a 5 min job, getting the exhaust undone off the cast manifolds was a few days of feeding some penetrant. Quite nice that all sports were a whisker loose , but one was 9 thou wrong. All going again and seems to have solved the noisy tappet
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
