Trevor there is usualy a brass gland nut that screws into the end of the exhaust manifold to hold the pipe . The threads have to be in good condition in order to get a sealed joint. A tubular copper washerfits between the manifold and flared end of the exhaust pipe. The first picture shows a Don Simmons exhaust system. 
I recommend Don Simmons for exhaust systems. The parts FIT.
Nice Cord.
The only person I know that repairs the threads in the end of the exhaust manifolds is Bill Bicknell in Missouri. He had special taps and dies to cut new threads in the manifolds and to fabricate new brass nuts to fit the larger thread.
 
 
Gary Parsons
I have filters in the lines to stop any debree reaching the radiator core. They have screw tops to access the filters for cleaning.
You can also get suitable copper sealing rings from motorbike shops as well. The tubular rings have a heat resistant material inside. Just check the ID and OD.
The gaskets I used were from Olsen. The exhaust manifold seals were copper tube rings with a packing material inside.
The head gaskets were steel on both sides. I queried Olsens and they replied they supply Cord head gaskets in two styles copper/steel and steel/steel
I guess they have variations in the exhaust manifold gasket too.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


