Hi Thierry, Start off by disconnecting the windshield wipers and put a vacuum gage on the engine and see what vacuum you are getting. Second is to pull the front bumper and transmission cover and see what is actually happening when you try to shift. Also check the battery is fully charged and the generator is working properly. These few checks should tell you where to start. 
 
If all the checks are good I have seen Cords that sit for a while and the brass contacts tarnish and don't pass power. it take 20 to 30 shifts to wear off the tarnish and get it shifting again.
 
Let us know what you find.
Jim
Hello Thierry you must be the guy I spoke to in Auburn in 2022. My brother and I were from Australia.
Hopefully your problems will be easily resolved.
"Ya gotta drive it more often". I can't go for a week without clicking up a few miles. It's good for me, as well as the car and I'm helping to educate people about Cords.
Hello again Thierry, the man I spoke to had the same name as you which is pretty much the same as Terry. I think he may have been from either Belgium or France.
Check out my Postings in the Picture Gallery.
If you are getting all the gears except 1st and Reverse it maybe the cross shaft diaphragm. This is leather and can dry out over time. What ever you do. Check one thing at a time and make sure it is operating correctly. 
Good luck, it can be a real challenge but once you have passed through the "intimidation barrier" you will feel on top of the world.
 
 
Hi Jim, Can you tell me where the brass contacts are located you referenced that can tarnish and cause problems with shifting and how best to clean them? My 812 sat for over a year and it shifted well prior to sitting, however now I canÔÇÖt get first or third to engage. All other gears are fine. I appreciate any advice you can offer.
P.S. I ordered the transmission manual from the ACD clubÔÇÖs eBay store and look forward to reading it but it has not arrived yet. Thank you in advance for your advice.
Hi Thierry,
 
The brass strips are on top of the solenoid bank. If you look closely at the base of the terminals on the top you will see the brass strips between 3 sets of two terminals. The best way to ensure there is good contact is to remove the top and install a jumper wire between the terminals. Email me at ob7879@outlook.com and I'll send you some photos of what I'm talking about.
 
Jim
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
