I am searching for the non supercharged type
Engine number FB1644
 
Than you
do you have any way to contact him?
thank you
That is a very interesting picture you posted of the oil bath type air filter.The Accessory Catalogue for Cords listed one at $15.00 although I have never seen an original one even when visiting Auburn.It is a good idea to modify the standard air filter to take replacement dry paper filter cartridges. It involves quite a bit of work to cut open the case and remove the original baffles however it all helps to protect the engine .I have attached the newsletter article showing how to modify the air cleaner. I cut mine at the other end for convenience.
Trevor it is basically an air silencer with very basic filtering. Modifying it to take a filter is a step in the right direction. The sheet metal is very thin so cut carefully.My air filter had been bashed in to allow for a bigger generator in the dim past consequently the opening cut was made close to the inlet end where the copper mesh is located.Eventually the damaged case was completely repaired making it look as good as new. 
Trevor there are lots of good modifications that can be done to make a Cord safer more reliable and help to preserve it.
I found the top half of my carburettor was warped slightly allowing it to suck air on the firewall side. See the attached picture, the gap was around 0.010". Some careful machining straightened things up.
 
Terry on my carb I found some stripped out threads on the air horn and this same joint warped in the front so gas was leaking out.. I used a lapping stone to flatten everything. So I installed Heli coils on all of them. I also found the accelerator pump lever bolt threads stripped out in the air horn. Seems those a re LEFT HAND THREADS... I bet not many realize this till its too late. I used a molecular metal epoxy to repair it.
Your carb is finished very well.
 
 
Gary Parsons
Gary, yes the LH thread surprised me too. I painted my carby silver and later realised it should have been zinc chromate which is kind of pale yellowish green.
 
Trevor some things to check on your Cord.
Are the wheels held on by nuts or bolts? If nuts then the hubs have been upgraded and probably to steel. If they are short bolts you may still have the original cast wheels hubs which are fragile.
What diameter are the suspension bolts that pass through the traverse spring and up through the trailing arms. The originals had from memory 1/2" threads on the ends .................... these are dangerous. The remedy is to replace them with 3/4" high tensile bolts.
 
Carb. parts can be related. Not too expensive and gas will not take the paint off.
CORDiallyMike
Mike, who does zinc chromate plating of carburettors?
What is the nominal cost of a carburettor?
I sent T-Bird carb. parts to Allstate Carburetor and Fuel injection in Central Islip NY. I have not gotten them back yet so can't comment yet about there results. There web. site says to color a carb. when you send parts only is about $85.00
CORDiallyMike
I did have on person reply he had an air cleaner and sent him a couple of private messages and have not heard anything back
So I am still looking for this air cleaner if anyone else might have one
Thank you
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.










