I recall something about turning an FB non supercharged engine into a supercharged engine but not a real FC engine. An oil passage needs to be drilled and some bolt holes needed to be drilled and tapped. The supercharged engine did have a very different cam, so the firing order was different. too. I'm not sure how a non supercharged distributor could work with the cam for the supercharger. Hopefully others will correct me if I spoke wrong about my post.
 
 
Gary Parsons
A Cord Super Charged engine (FC) can run with a single or dual point distributor, you just have to change the firing order and the timing by a couple of degrees. The advantage of the single point distributor is simplicity as the dual is difficult to set the dwell of both points without proper equipment. The disadvantage of the single point is judging and slightly less power at higher RPM's. The S/C cam, I believe, has the same lobe angle as the non S/C but has the gear to drive the actual S/C. Jim may have better info if the cam lobes are more like a 3/4 cam for more power.
 
Hope that helps - Mike
Just to add something overlooked so far in this discussion is the FC supercharged engine had a 1 1/2 inch wide timing chain the same pitch and number of links as the FB non supercharged chain that had the 1 1/4 inch chain. Original chain was the Whitney timing chain.
 
 
Gary Parsons
The FB blocks were normally asperated. The FC blocks were Supercharged. The blocks are "basically" the same. It is possible to put a supercharger on an FB block by drilling the oil passage for the supercharger and adding the mounting bolt holes and water passages for the supercharger. 
 
The cams were different between the two engines. Frist was the firing order. The standard engine fires all the cylinders on one bank then the cylinders on the other bank. The supercharged engine is a cross firing order - not a true cross fire though at two points in the firing order it fires two cylinders on the same side. Also the cam profile is different as is the valve overlap to account for the supercharging.
 
The timing chain is larger on the S/C engine due to the larger power required to drive the camshaft. Although both were undersized
 
The FB engine used a single point distributor and the S/C engine used a dual point distributor. The distributors had different advance curves. Yes they can be interchanged but they don't run quite right.
 
Also the valve springs were different.
You are right Cliff, I did forget about the side mount fuel pump.
 
For others - The FC block had a side mount fuel pump. The FB block had a top mounted fuel pump that doesn't fit with the supercharger, hence the reason for the move. However the very late FB blocks did have the side mount fuel pump.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
