Hi Robert, my rotisserie is probably the one you are referring to. I made it with odds and ends I had lying around and it worked quite well with my sedan body.It is now in the hands of a phaeton owner. It uses the existing holes in the channel stubs at the front of the body and the holes at the rear of the body where the bumper supports are fixed.Attached are some pictures. Sorry I don't have or kept any close up details.At either end is a long piece of threaded rod that is used to raise and lower the body. There are clamping plates to hold the body at the right height. I used a tube spanner with handles welded to it to slip over the threaded rod in order to raise and lower the body. 
Nicely done Terry. But spooky too. Getting the balance correct would worry me. Once the body gets moving not much is going to slow it down. I wish I had the space to use this restoration approach.Thanks for the great pictures too. I have ideas now...
 
 
Gary Parsons
Gary there are a couple of bolts at each pivot point to control the rotation. They take up the slack too as I didn't have any pipe that would be a closer fit.
Rotating the body was a case of trial and error.
The guy with the phaeton reported that he had to raise it almost to the maximum height to be able to rotate it. That was because there was no metal roof to balance the lower part of the body.
It took about a week to design it on the knee and make it.
Counter weights could have easily been added to the threaded rod for use with the phaeton to keep it lower.
I have a body rotator also and will give a warning. I used the rotator on a 1957 Thunderbird. All worked well and the balance was great. Could move to any rotation and it was balanced so will wouldn't have even had to lock it. Then I put the hood and trunk lid on to paint. Not so well balanced then. Got away from me. Be careful.
CORDially Mike
Mike you have to remember to tie up the doors with rope too. Actually my rotisserie was constructed to transport the body to the grit blasters as well as rotate the body for blasting. The blasting plant was over 100 miles from home. Most of the car was blasted over a weekend. It was quite an ordeal but had to be done. Everything was sprayed in primer after blasting. A second trip was made with the hood, front fenders and grill. 
I had access to two different types of rotisseries. I will post photos of how I mounted the Cords below. The balance is important, but both rotisseries had height adjustment. I just had to experiment a bit made sure that I had the center of gravity lined up with the axis of rotation.
 
 
 
 
 
 
To answere your question regarding the rear mounting I put the bolts through the holes where the bumper bar supports are mounted. I placed a wooden spacer between the body and rotisserie supports to allow access for grit blasting.
With hind sight I should have made the frame a bit wider at the rear to accommodate thicker wooden packers.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.






















