RH
@rhauser
Replies (9)
R
the only place I saw Screws and nails was on the lip where the trunk lid sits. is that the only place that it is attached? I have removed some of them but it doesn't seem to move at all. The upper wood I do see how it would come out.
U
Besides the wood screws and nails, the side pieces of wood are attached to the bottom piece of wood with a U shaped brace on each side and I believe you spotted the braces at the top.
U
I said U shaped bracket but I should have said L shaped bracket. ItÔÇÖs screwed from the outside side of side pieces and bottom side of bottom piece
R
thanks for the reply. I have removed the wood around the trunk but in looking at your photos it looks like this is new wood. Do you have the jigs to make or did you have someone make this for you? I need to replace some of the wood or have a new one made. I also need the piece on the phaeton that goes around the rear tub above the trunk piece.
thanks
T
Your frame can be used for templates. I used a band saw to cut each separate piece then glued and screwed them together just like the original.
G
Terry From what I can find the factory wood shop made these frames but when they were installed some needed shims. My 810 used a number of them to make it fit the metal work.
T
I agree with that George, packing pieces of thick cardboard like the firewall pad was made of were used to fill in any small gaps.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.







