I have the 3 bolts and housing removed. will the arm slide off of what it is riding on attached to the frame side. I don't want to prey on it if it is attached with something on the frame side. I don't see anything but i don't want to prey till I'm sure.
 
thank you
When obsolete bearings are encountered You can find a bearing with a larger shaft size or smaller housing size and make bushings to make up the difference as long as the bearing loads are comparable to the bearing you are replacing.
CORDiallyMike
Mike the inner bearings are still available however the outer bearings have to be made up using two taper roller bearings with a spacer between the outer rings.
This has all been covered under the restoration done by Rudy in France in an earlier Posting.
The original outer bearing was a one piece assembly.
Thanks everyone I got it apart last night. I little PB Blaster and a bigger hammer did the trick. LOL
 
the next question is how can you get the roller bearings out. I may be mistaken but it look like it is more than just a press fix.
I used a scarfing tip on my oxygen ecetylene rig to remove the bearings. If done correctly the frame never gets damaged because there is a air barrier between the cup and the frame like is with any item your trying to cut out of any parent metal. Its a dellicut feel to get this right. PB Blaster and heat may help with a hammer and punch. Or use a Portapower hydraulic ram. Sometimes even a large socket and clamp can press out the bearing. I learned all these still many years ago working in power plants and machine shops. Hitting the cup shocks the rust that is holding it in the frame. When rust grows between two surfaces is developes 50,000 lbs of pressure holding thing in place.
 
 
Gary Parsons
I used a hydraulic jack and push bar to remove the needle roller bearings, however the frame had been removed from the body and turned on its side.
A porta power can be used horizontally within the frame.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
