Am not sure about a difference between the supercharged and non supercharged bell housings. But am following this to learn if there is. I know the bolt pattern MUST be the same.
Now for the powder coating the inside n outside of the water pump... Seems like its an extra cost. As for increasing the flow.. Not sure if it will do that. Maybe grinding and sanding smooth would be enough like a valve port job does..
 
 
Gary Parsons
HI Robert,
There is no difference between the standard or S/C bell housings. The bell housings, like every other part on a Cord, has at least two versions. In this case they are interchangeable.
 
On the water pump - the answer is be careful. Yes a smoother surface will give you better flow. However, powder coating adds thickness which may give you clearance problems depending on how much is added and how bad your pump is to begin with. The real question is how much will it help and is it enough to make a difference. Also how is the powder coating going to respond to 200 plus degrees. Also make sure you don't coat the seat areas.
 
I think you are better off getting an improved impeller to get better flow.
 
Jim
The down side of powder coating is removal. As we all know many times something has to be redone for one reason or another and removing paint is much easier than powder. Not saying you should paint the inside of water pump!
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
