Bill These are a VERY RARE item. They are a nice bling addition to any Cord. As to knowing what model I suspect only one was made. Reason for this is the accessory booklet only shows one and it is not model specific. .there is a special black rubber gasket to fit in the dash holes too. These is also a aluminum flexible tube running from the heater to the vent. Looking at this example with the casting flaw I suspect someone tried to casta reproduction. This is still a very nice piece of a very difficult to find part.
Gary Parsons
Thanks Gary, I appreciate your comments. I had not thought about the possibility of this being an attempt at a reproduction, I had assumed that the broken through areas were due to corrosion although it is a bit odd that it is only on one side.
I donÔÇÖt think that I have a copy of the accessory booklet, could you share a picture of the relevant page?
Thank you.
Bill
Hi Gary,
No need to attach the picture, I found it in an earlier post by Terry Cockerell.
Bill
Hi Bill.
The defroster casting you have appears to have been on offer from November 1936.
It is listed as Accessory No 13, see the attached page below from the Accessories Bulletins.
The earlier unit on offer was a small fan which could be aimed to blow air on the drivers windshield only.
The casting outlet you have could be used on sedans as well as convertibles.
I noted one of these demisters in one of the Rusty Recks Rotting and Residing In Rural Riverton, South Australia.




Sedans and convertibles are different. They look the same but the distance between the "horns" are different.
E LJun 8, 2026 Sedans and convertibles are different. They look the same but the distance between the "horns" are different.
I assumed incorrectly that they were the same as no difference is noted in the Accessory Bulletin Installation Drawings.
Re-reading the First Page of the installation notes it says "When you order the defroster assembly do not fail to specify whether for sedan, cabriolet or phaeton."
George can you give us the actual dimensions?
Thank you Terry and George, this is very useful information. I will compare the vent that I pictured to the one that is in my phaeton to see if they are the same. Based on the picture that Terry provided it looks to me like the distance between the horns may be greater on the closed cars probably related to the fact the the closed car windshields tilt open.
Terry, just as an aside, it sure seems like a bit of a waste for that defroster vent to remain in that poor car that will likely never make it back to life.
Thanks again to everyone for your help.
Bill
Bill. That rusty Cord is being used for parts. It was sold at an auction in South Australia. I believe it had been imported from the US then left to sit out in the open.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
