Graham this was done to my Cord by a lazy panel shop repair guy. I didn't like it being done however if you are concerned that lifting in the centre will distort the axle I think the answer would be no it would't do any real harm.
The axles were subjected to pretty vicious treatment on unmade roads particularly here in Australia as well as not so wonderful pavement. If your Cord handled that you have nothing to worry about.
Normally I use two trolley jacks as I don't have room for a hoist.
Hi Terry, someone must have done it, did it bend ?
Wanting to adjust rear brakes without twisting the frame and putting tension on the handbrake cables. I know there are many ways to do it, just curious.
I sure would NOT jack up my Beverly by the center of the rear axle. These cars do have a significant frame under them. I would place a jack under the frame just forwards of the rear leaf springs and lift one side. Adjust the brakes. Or, you can lift each side by using two jacks on the frame rails.
 
 
Gary Parsons
DO NOT jack up the car by the center of the rear axle - IT WILL BEND!
Terry - you got lucky it didn't bend.
Jim the guy used a huge trolley jack with the lifting head or cup around 4 to 6 inch diameter. I am glad that it was not a point loading.
What sort of loading was the rear axle subjected to at speed of around 50 mph if one wheel hit a pot hole in the vicinity of 3 to 4 inches deep?
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
