HDVETTEApr 12, 2026 I would like to upgrade the Lockheed brakes on my 810 Cord. The easiest would be the '37 812 Bendix brakes but I wondered if anyone had found any other conversion that might be more readily available. I have not been able to locate a set of '37 Bendix brakes.
Contact Pat Leahey. His details are in the Directory. Recently he has come up with a cost effective alternative solution using modern brake parts.
I drive a 1984 Ford E150 which also has 11" brakes. I am presently considering converting the Ford backing plate and using all Ford parts for the rear brakes on my Cord. I have not looked at the front brakes yet. The original Cord brake drum might work but I would sooner slot the holes in the Ford drum and use them. Ford wheels have 5 bolts @ 5 1/4" where as the Cord has 5 bolt @ 4 3/4" I am still measuring and comparing. Some custom wheels have slotted holes so they can be used on different bolt patterns so I do not see a problem with slotting the brake drum holes. I have to have new heavier rear hubs with wheel studs made first before I proceed with this.
Tom
have a full set of bendix ready to install.
mmsfld@aol.com

E LApr 12, 2026 have a full set of bendix ready to install.
mmsfld@aol.com
By far the easiest upgrade you can make.
I have a prototype modern Bendix brake setup that I made from this kit from Speedway.
https://www.speedwaymotors.com/9-Inch-Ford-Drum-Brake-Kit-5-on-5-5-5-Bolt-Pattern,506473.html?
The bolt pattern on athe 810-812 is 5" x 5 lugs. The drums in this kit are dual drilled.
The biggest problem is the center hole is too small and incorrect bolt pattern. Also the Cord front is different than the back. I was able to machine a flange to match the front brake diameter and hole pattern and cutout the new back plate. The Cord is a vary shallow offset compared to the Ford.
The kit listed is setup with parking brake assembly (you need the Bendix rear cables which I have already made). I was working with Cord brake drum and hub. The unit I have completed for the front has yet to be mounted and tested. This setup has self adjusters also. The shoes, cylinders and hardware work with original Cord Bendix back plates. I also have this in stock. I also had a new hose made up with a 90 degree fitting to ease installation. The first picture is before modifications. The second picture is after modification with Cord knuckle installed.
If this works this works OK, this will be a great improvement at a fraction of cost of Cord original Bendix.
Pat Leahy


My Cord wheels must be oddballs because they measure 4 3/4" or actually closer to 4 11/16"'. This would not surprise me as I find variation in many Cord parts.
Tom

Check this diagram for correct measuring.
.jpg.2b3575094b32a6d9b54baac17a425b4a.webp)
Thank you for this information. I have been doing it wrong all these years.
Tom
Thanks Pat for this correct way to measure wheel bolt pattern. I too have been measuring the 5 lug bolt pattern wrong for over 60 years. I bet Tom was rowing in the same boat as me.... It seems ONLY the 5 lug measures from one center to the edge of another but all the rest measure from center to center of the lug bolt holes.
Gary Parsons
Guys the five holes are on a Pitch Circle Diameter of 5"
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
