On any bolt, the thickness of the head is never included in the measured length. Hope this helps you find what you are looking for. I'm located about 80 miles north of you. If you need me to look at something I can drive down most any time.
Gary Parsons
Questions.... Where are you finding these new bolt lengths? I believe Stan in Wellington Kansas has the bolts needed for new head bolts. But they have the new strenght marks on the heads and they are NOT as thick on the heax as the original head bolts are. ALL these head bolts enter the water jacket. So I'm thinking length is not important. But please wait around for others better in the know than me.
 
 
Gary Parsons
To Tom in San Diego.
It's been too many years to recall the correct lengths of the Cord head bolts, but let me add a major caution. Cord blocks have been ruined by using bolts extending too far and crushing the inner casting of the block on the far side of the water cavity. Different lengths are used depending on the thickness of the head. E.g. original, Bohnalite, or newly cast. This is in addition to the different lengths depending on what row they are in on the head. Some of the current Cord club members will know. So before putting a bolt in, check the depth of clearance for whatever bolt you use. Tom Hartz
I appreciate people pointing out that the wrong head bolt lengths can damage the block. I already knew that; that's why I'm asking the question. I was mystified by the question of where I got the lengths in my original question when I started by stating just that. But just to further clarify that, I've attached the cover of the manual and the conflicting source pages. I've also included a drawing showing my measurements of the depth of the holes in my heads. What I would really appreciate is someone measuring one of the longest stock head bolt they have on hand and reporting the result here. Thank you in advance.
Thanks for the wakeup Tom. I sadly missed your comments in posting. I usually am not missing anything in a members post.
 
 
Gary Parsons
I have never seen bolt lengths include the heads.
CORDiallyMike
I wrote "I have never seen" not never. I can't. I am talking about bolts in general, and don't now about 810/12 Cords in particular.
CORDiallyMike
The original bolt lengths listed in the parts list are for the original heads, with original gaskets and original washers. These days very few people are using original heads and original washers. No one is using an original head gasket. Since there have been several different "new" heads made over the years, the best way to determine the length of bolts you need are to measure. First measure the washers you are using - Check them all. Measure the thickness of the head at the bolt holes. There are three different thickness at the bolt holes. Measure the thickness of the head gasket you are using.
 
Last is the thread engagement - as a general rule the minimum thread engagement should be 7/16". Check all the holes where the bolt may bottom out to see how much you have from the surface of the block to the bottom of the hole. Make sure you leave a gap and also allow for gasket crush.
 
The bolt length (blot length is measured from the bottom of the head) you need will be the sum of the washer, head thickness, gasket thickness and thread engagement.
 
Lastly make sure the threads in the block are good. If there are any questions put threaded inserts in the block.
WEll said Jim.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
