

It was hard to get decent pictures, but the shot down the firewall shows you how it feeds through the frame. On the other side the red wire cuts over to the clutch switch and then the harness moves to the top of the frame and then over the top of the front axle. In the front, it runs just inside the radiator.

I used the one piece harness and the fake plug so the wire ends up with maybe 2 or 3 inches of slack all the way up at the interlock switch which you can pull back around the solenoids.
 
Honestly, I could not imagine having to solder the plug end on at the bottom of the steering column.
Thanks, Cliff. We learn something new every day.
Tim.
Tim, thinking more about this topic. It would have made sense Production wise to run the looms together on the LHS of the frame. It only requires one set of cable clips and the associated nuts and bolts to fix them in place.
The headlight loom crosses the frame at the back of the brace under the radiator, while the gear change loom crosses at the front of the brace.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





