Many thanx!!!
So now I have the horn ring off. There is a hole for a setscrew(?) in the back of the wheel. The hole is empty.
The wheel is threaded very tightly onto the shaft. The only way I see to hold the shaft firmly enough to back the wheel off would botch up the shaft's threads.
What am I missing here?
Sadly the wheel was never drilled for threaded pullers. A member made a wooden puller to remove his wheel. Once you can the large nut removed from the shaft apply some Aerokroil or PB Blaster to the wheel and shaft. If you try to manually pull the wheel off the shaft by hand please put the nut back on the shaft. Otherwise you may end up traveling to the back seat area when it "lets go"..... Been there but only once.....
 
 
Gary Parsons
Terry, Foolishly, I was looking for a fast, down and dirty method where I didn't have to build anything. I still have your drawing
Thanx, Bill
Usually the fast down and dirty way results in broken parts!!! Henry Portz once told me that most problems with old cars are caused by the owner.
CORDially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


