Its easy now. As posted above.. Feel up following the armored cable to the junction. Pull it apart. Then take bucket to work bench. Inside this bucket is 6 flat springs in twos. You need to push in the lens enough to take some spring pressure off the lens retainer. Then it easily comes off. Then let off the pressure on the lens easily till you can lift out or flip over the bucket and let the lens drop out of something soft. Those threads coming out the back are the clip retainers for the frosted lens. Its supposed to light up the trunk when the tail lights are on. Am not sure it really does much if any trunk lighting. Later tonight I can share pictures of everything I have posted here
 
 
Gary Parsons
Hi Gary and Bill,I happened to have removed the lens from my tail lights so that I could replace the bulbs with LEDs to make them brighter. I took some pictures and maybe they will be helpful and/or interesting to you. Attached is a picture of the tail light body with the lens removed which shows the mounting of the frosted window for the trunk light and also the springs that apply pressure the the tail light lens. It is these springs that Gary refers to when he says that you need to press inward on the lens so that you can remove the stainless retaining trim ring. I have also included pictures of how I tried to maximize the brightness of my brake and tail lights. While the idea of using the tail light as the trunk light is economical I considered it a great waste of light that I would prefer to use for the safety of brighter brake and tail lights. To that end I added some reflective plastic material inside the tail light body so that light from the bulb would be reflected back out the tail light lens. In the pictures you can see that I added one piece of reflective plastic that covers the frosted trunk light window and another piece that circles the inside of the body around the bulb. Also shown is the 6 volt LED bulb that I was able to (barely) get inside the housing. All I can say is that now my brake and tail lights are very bright. If you are interested in more information about my LED installation or the parts that I used please give me a call or send me an e-mail.Best regards,Bill Kastanis (707) 494-0715 Rileypu29@yahoo.com
those are great pictures of what I explained early on in this posting. Another idea about increasing brightness we can paint the inside of the bucket white. I believe Terry Cockrell used small mirrors in his buckets to reflect more light. Then Jim O' Brian published a type of bulb change that really brightens the tail lights. It was in a news letter magazine few months ago. Very well written.
 
 
Gary Parsons
Just a suggestion:
Do 1 side with an original bulb and the other with an LED bulb and then make up your mind. Check both at night and a sunny day.
Pete
Bill,
The LED will function as both brake light and turn signal if it is wired up correctly. However if you are running LED bulbs for the turn signals you need an electronic flasher.
Jim
Hi Bill,
I sent you a private message but I don't know if you received it. When I bought the reflective plastic film I bought a whole roll and have more than enough for all of the Cords in the world. I would be happy to mail some to you (or anyone else that would like some) if you send me a private mail with your address.
Best regards,
Bill
Reflective PLASTIC OK LED. Maybe too much heat from bulb, will melt? For sure with Halogen.
CORDiallyMike
Hi Bill, I'm gonna have to check my email in the directory. It's no secret :wcoye1@gmail.com. Thanks for the offer. I Amazoned some thin plastic material that's laminated to paper or really thin card stock . I'll give it a try tonight. My only concern is getting the stuff over and in back of the socket without ruining the shiny surface. If it dosen't work I'll take you up on your offer.
Bill
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




