Yes Trevor that is the place to start and after the filter.
I would NOT be using a modern transmission oil filter as the gearbox oil is too viscous but a tube surrounded by fins. I'm gathering information on options at present. There are two locations where it could be fitted namely in front of the radiator or under the gerabox. Both have pros and cons.
Terry,
Before trying to install a cooler - are you sure there is a problem? I have rebuilt 40 to 50 transmissions and each one I have very carefully inspected for problems/issues. I have never seen any indications of "overheating" due to external temperatures or normal running. This includes the gearbox oil.
 
I run Lubriplate SPO-277 in the transmission and that will easily handle 250 degrees F without breaking down. I don't think the transmission gets near that temperature, even in the hottest weather. As long as you are running a good modern lubricant there should not be any problem overheating the oil or the transmission.
Jim
Thanks Jim. It is a project I felt was worth looking into and that maybe others had done already.Quite a few years ago I drove down to Sydney for a photo shoot at the site of the former Auburn Cord Dealership. It was early on a Sunday morning when there would be light traffic.The trip home later in the day was a killer. I was driving into a 93 def F headwind. The engine temperature gauge was on 195 deg F and thankfully didn't go any further as my Cord has a shroud. The heat behind the wheel was horrific as the insulation was virtually non existant and there were numerous extra holes in the firewall to let the heat through.I drove the car on the temperature gauge the 60 miles home. I have no idea what the gearbox oil temperature would have been however if the engine runs better at 160 deg F as it normally does in cooler weather I figure the gearbox could do with some cooling.Note the middle picture shows the building used by the Dealership. It was eventually demolished in the 1970s
Terry you might look into air conditioning coils that have fins welded to it. You may not be able to find the exact size you need but something along that line may help with cooling. I know Jaguar has several different types of coils on the V12 engines. One was for the power steering fluid and another was used with the AC units I think to cool the fuel. Ford and Mercury also used a power steering cooler.
 
 
Gary Parsons
Thanks Gary, I have in mind using piece of aluminium barstock and using a parting tool to generate the fins. That will at least have to wait until next year.
The type Trevor posted pictures of have the fins in the wrong direction for my application.
It probably would have a flat strip tack welded inside to create two chambers.
Thanks mate,
Terry
Before going to all that trouble I would see how hot the transmission actually gets with a infrared gun. Ab was racing remember.
CORDially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




