Wow Wyn, that is probably the quickest answer I have ever received complete with pictures. Thank you very much. I will check it out tomorrow.
Regards,
Terry
Wyn, Your handle has been modified to hold the plate and spring in place. Originally four corners on the shaft were upset to hold the plate in place. You can still see the indents on your shaft.
Jim
Wyn, Your handle has been modified to hold the plate and spring in place. Originally four corners on the shaft were upset to hold the plate in place. You can still see the indents on your shaft.
Jim
 
What Jim has posted is correct. But it would seem to me this is something that helps compared to the original crimped corners.
 
 
Gary Parsons
Wyn, no apologies necessary. I looked for a roll pin and not finding one realised your handle must have been modified. The mod works so I will be talking with my mate who owns the handle.
Thanks also to Jim and Gary.
Thanks Jim, it is from Thomas's RHD Cord serial No 812 1600 K.
He has given me the go ahead to operate.
Do you have a key Terry?
CORDially Mike
Hello gents,
 
Thanks kindly for all your responses - this has been most interesting to read. IÔÇÖm the owner of 812 1600K, the Cord that (hopefully one day!) this door handle will go on.
 
Out of curiosity, how rare are the lockable handles?
I believe the door handles fit both sides and front or back doors but. There is a different length square shank on the convertibles compared to any sedan. We can cut down a convertible door handle to fit any sedan. But adding lenght is a little harder. Also some owners have found if the handle is not lined up we can twist the shank in a vice to gake it look correct. Adding some heat carefully to the twist area to be done with caution. Note to everyone. A wet shop rag protects the chrome.
 
 
Gary Parsons
Bill if it works.. Then fine.Many years ago I think it was Jime Obrien or Pat Leahy or Josh Malks found out that a GM clip worked great when the flat spring clips began to fall out of loose the flex in the spring.I do not know the year but if used it sure would make removing the handles easier they the two screwdrivers thru the two holes in the door.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




.JPG.c03a2cdb033aacc4d2a616d2c686da2b.webp)