Hi Terry,
 
Just a couple of thoughts off the top of my head -
First question is why? Other then being able to make them yourself I don't see an advantage.
What copper would you use?
What thickness would you use?
I don't think I would worry about the galvanic corrosion as the original gaskets were two sheets of this copper around asbestos.
I would check out the thermal expansion of the copper vs. aluminum, cast iron and steel. You have to consider the for the clamping forces between the head and the block and also the across the face of the block/head interface.
If you are using soft copper, I would be concerned with it will hold the torque over the long haul (cold flow).
 
Jim
Hi Jim, thanks for your prompt reply.
A pair of Olsons head gaskets cost $465 Aust including shipping which is pretty steep. One gasket company here in Australia says they can make gaskets like the Olson type for $600 Aust plus postage. Another company offered solid sheet copper gaskets.
In the past I had owned, ridden and maintained Triumph motorcycles which used solid sheet copper head gaskets with aluminium heads as well as cast iron heads. The same head bolt torque being used on either head.
The enquirey was to determine if solid copper could be used.
The company offering to make the gaskets is not offering in depth technical advice.
It would seem to me if Olson's would make solid copper gaskets for a lot less money, they would sell money more gaskets. Since they go to the trouble of making sandwich gaskets there is probably a good reason. $465 looks much cheaper when you are stranded on the side of the road with a blown gasket. Towing fee, embarrassment, tearing down nicely painted, detailed engine, and then ordering the $465. gaskets after all.
CORDially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
