The gear is removable; keyed and held in place by a nut.
It would be hard to get the cam in with a 4" gear attached.
Pete
Thanks guys, the subject came up during a conversation down here. I had no idea of the drive gear diameter.
I suppose it would be rather difficult to thread a 4" diameter gear through the block. Obviously from a manufacturing point of view is makes sense to make the parts separately. They had the complete design laid out of the supercharged engine in early 1935.
Supercharging was taken into consideration for the initial design. The blocks were all cast the same except for the relocation of the fuel pump later on. When superchargers were fitted the mounting holes were drilled in the lugs at the top of the valve chamber. The wide journal on the camshaft was machined to suit the adjacent bearing. They expected to be able to use the original camshaft however it had to be redesigned to change the firing order during trials with a supercharger fitted. It's all explained in Josh Malks books.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

