Terry, I would be interested in knowing why you think .008" is too tight.
 
I have run that clearance for years with no problems. Increasing the gap will reduce the opening of the valve and reduce the ability of the engine to breath. There is a considerable amount of engineering that goes into the valve train. The gap is one of the critical parts of the design.
Jim
Jim being a novice in the past I set all of the tappets at 0.008" following what information I had and proceeded to cover around 10,000 miles in five years. As the restoration has unfolded more time has been devoted to everything. Roger Von Bergen who has been involved with Cords since the mid 1950's advised me to increase the exhaust tappet clearance to 0.010" Looking into this I remembered all side valve engines that I had worked on in the past had a greater clearance for the exhaust valves. As the exhaust valves get hotter than the inlet valves they need a bit more space for expansion. Side valve Ford V8s are the same but with larger clearances.
I believe that the original Factory wiring diagram for the gear change system has an error. So not all Factory information was absolutely correct.
The Topic was put up for comment for the benefit of the members.
I also had to replace the exhaust valves during the rebuild.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
