Its a great product. I have never used it but its used in semis over the road all the time. It never needs to be changed. Its best to use it on a new clean system as in after a complete overhaul. Always carry some extra just in case you "find" a leak. Our cooling system is a zero pressure cooling system and the overflow dumps to the street. Thats why we run the coolant low in the top tank. Expansion will cause coolany loss. I understand its flammable too. I will ask around for members that have used it. Am not sure if Randy has used it. I know Ron Irwin uses something similar but will need to ask. I was once told NASCAR used it but had a 35 lb cap because higher pressure insures it contacts all hot areas without boiling off. Not sure if I believe that ...
 
 
Gary Parsons
This has been talked about a lot on this forum. Not a fan.
CORDiallyMike
I agree with Mike.......not a fan either.
 
Ed Minnie, Lehrman Collection.

Sorry for this late reply as we have been away for a few days. Discussing this product with others here in Australia it seems that Evans Waterless Coolant has a higher viscosity than water which reduces flow rates and heat dissipation. It is ok to use in a system that has a lot of reserve cooling capacity. Consequently this product is not suitable for Cords that tend to run hot. Thanks for your contributions.
Josh Malks used Norosion which needs to be monitored and tested for PH levels. Norosion is a corrosion inhibitor and does not have anti freeze properties.
There are other products out there that have a long life like Evans .
I will keep you informed as to what turns up.
Terry have you researched a product called Water Wetter? I used it in my Ford diesel coolant and was very happy with how it preformed. It makes watter wetter so it can cool any engine better.
 
 
Gary Parsons
Gary what I am really after is a coolant that is corrosion resistant.
I had pretty well beat any tendency for my engine to boil with the modifications I had made. On a real hot day and heading into a hot head wind it had risen to 195 deg F but would not go any further. I have read there are corrosion inhibitors available that are good for 5 years.
I just had a look at Water Wetter, it says it is good for all modern engines.
I guess I will contact the manufacturer for further information
I will keep you posted, thanks Terry.

From reading through all the Evans stuff, it has a higher boiling point but also tends to make the engine run 5-10 degrees warmer. I believe Jay Leno uses it. I also would like a recommendation for a rust inhibitor.
 
In the past, I have had good luck running a car on evapo rust for a week or two and draining. The amount of crap that comes out is amazing.
In the past I had to remove sediment from the block that must have filled at least half of the water jacket space. The radiator was blocked so a new core was fitted. Henry Portz advised me to fit filters between the heads and radiator which I did. The filters continued to collect an amazing amount of rubbish that would have gradually clogged the new core.
This time with the car's first ever complete restoration everything is clean with the aim to keep it that way.
After looking at various products I have selected SCA Corrosion Inhibitor Type B, which is based on Organic Acid Technology or OAT.
Contacting the manufacturer I was assure that it would be suitable for my Cord.
It has been designed for older engines that do not require glycol coolants, anti freeze or anti boil protection.
It is for long term use up to 3 years giving protection against corrosion for cast iron, aluminium, brass, coper and stainless steel.
It has to be premixed with demineralised water.
I just have to finish assembling the engine to give it a try.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
