Thanks for your comments. I am looking forward to driving my Cord again when the complete restoration is finished ................... early next year.
I covered about 10,000 miles in 5 years and hope to do a lot more.
I had thought the Startix would work without the restart function and without the need of a push button. Thanks again "UCONN".
Thanks for the picture. I also prefer to hide any extra gagetry where possible. Two extra gauges I have a mounted on a hinged plate so that they can be put out of site for shows etc. One gauge monitors gear box oil pressure while the other monitors the temperature of the RH cylinder bank. No coolant passes through the inlet manifold. You will also note a strip with LED lights between the dash and ash tray. These are gear selection lights which are a bit of a novelty but work very well especially with novice drivers.Red is for reverse and Green covers the Go Gears. 
IÔÇÖm curious. I donÔÇÖt see a shift arm. How do you shift?
I too was wondering that.... Maybe sticks and levers.... I'm sure Terry just has not installed that yet.
 
 
Gary Parsons
The gear selection switch complete with new wiring has subsequently been installed. Back down the Forum page is a topic I wrote on Gear Selector Wiring which has had over 6,400 hits.
I'm getting close to finishing the restoration which will probably string out to March 2021 by the time it has been debugged.
Terry,
Would it be possible for you to send me this Startix modification? It sounds interesting and I might want to try it as I restore my Cord.
THanks,
Jim
Jim.
The article says to leave the generator wire disconnected.
I figure if it is disconnected and taped up inside the Startix box then the generator wire can be connected on the outside to make it look correct.
I am about to rewire my startix to use a manual start button but have run into a problem.
When I first started the car I used a standard 6 volt solenoid which after a few starts the contacts welded together, This happened to the second one that I tried.
I then hot wired my startix and used the manual button and the same thing happened.
My car is using two Optima 6V batteries wired in parallel giving a reading of
6.8 Volts and the engine is grounded direct to the battery.
The cables are all heavy six volt cables.
Any ideas?
Thanks
 
Steve Koller
You are positive ground?
CORDiallyMike
Mike,
 
It is Positive ground and is wired that way.
Any ideas?
Steve
Have you checked the amp draw on the line to the starter?
Have you tried it with just 1 battery?
I use i wet cell battery with about 550 CCA with no trouble. Why do you need two Optima? That's a lot of Amps.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.













