Sorry Terry. I spend nearly three hours searching for this spring. But it has found a hiding place and wont come out to play. I recall Henry used to test run the pumps he rebuilt but no idea what he used as a test bench. Maybe he just filled the pump with oil. Bolted it to a block plate and ran the pump watching a test gauge. Adjusted for pressures. Will continue looking later.
 
 
Gary Parsons
Thanks Jim.. I have seen this on my work bench...Isn't there a sliding plug type seat that this spring holds closed till a certain pressure is reached?
 
 
Gary Parsons
Jim and Terry. I "found" a zip lock bag of gears and parts to my original trans oil pump. From my best recall I did not have a ball but had this plug to be held against the seat for pressure regulation. It seals very well but I plan to test it better before commiting it to the design. Have either of you seen a plug instead of the ball?Gary Parsons
Thanks Terry. This has been my plan but... I'm trying to "feel" the seat or see what it looks like deep inside the cover. It amazes be the "repairs" I have found in this car restoration. I tested the plug to seat seal with brakclean and nothing leaked by. Am hoping the mechanic didn't modify the seat to accept the plug.
 
 
Gary Parsons
Jim, as I don't have any shop manual info yet, what is the pressure this releases at?
Thanks, Ken - 812 SC
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


