Terry,
Clean off the top machined surface of the case. The numbers should be between the cover and the 4 bolt holes for the solenoid, on the drivers side. Most of the cases I have seen have an ID number as well as the drive ratio. However, among my spare transmission cases I have one with no numbers at all.
CORDially, Mike
Hi Gary.
This is very interesting as T585 refers to a Type 2 transmission from Sid Ayres book. Also the number should have been on the top machined surface of the case and at the rear left side.
I am not missing any parts as the interlock mechanism had been unbolted when the picture was taken, same as the top cover.
I will have a closer look at the side of the case above the stiffener.
Thanks,
Terry
Terry: there are a few cases out there that have the number stamped on the side of the case. Look carefully; may be a light stamping.
Tim.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.







