I hope the experts here on the club site will correct me if IÔÇÖm wrong. I donÔÇÖt think you need to index the oil pump/distributor drive gear. This is the way IÔÇÖve always done it. When the engine is assembled, turn it over until cylinder #4 on the drivers side (cylinder closet to the firewall is top dead center on the compression stroke. Take the distributor cap off. The rotor needs to be pointing to spark plug wire 4L. It probably wonÔÇÖt be. At this point remove the distributor and take out the distributor drive shaft. There is a slotted screw holding the upper part of shaft from turning on the tapped part of shaft. Loosen this screw so upper part of shaft is free to turn. Reinstall shaft and distributor. Now you are manually able to rotate the rotor to the 4L cylinder wire. Now again remove the distributor and drive shaft and TIGHTEN the slotted screw so upper part of shaft wonÔÇÖt turn. Reassemble. You now should be pretty close to being ÔÇ£in timeÔÇØ and should be able to fine tune when engine fires by adjusting and advancing or retarding the distributor position.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.