Hi Tom I assume the 812 steering box is the same as the 810. The worm gear is just pressed onto the steering column shaft. Removing the worm is fairly easy to do.
Pushing the worm back onto the shaft is not so easy.
The worm has tapered ends which form the inner cups of the bearings.
Tom,
It's my recollection that it is a very tight fit and the worm gear is rather soft.
The advice for must worm gears is don't remove unless absolutely necessary.
CORDially Mike
Member Pete Kelly phoned me and told me the collar on the steering wheel shaft has a set screw. Remove it and slide the collar off. the worm gear with the shaft can now be removed from the bottom of the housing. After some cleaning and close inspection I found the set screw and the worm gear and shaft slid out. The worm gear does not have to be removed from the shaft. The bearings look good so a new seal and output shaft bushing should be all that is required. Another Cord problem solved.
Tom
Tom try putting the steering column complete with the worm in your lathe and check the shaft for concentricity at intervals along the shaft.
Mine was all over the place and took quite a bit of work to straighten it up.
The worm gear is definitely hardened all over. Mike Brady is probably thinking inadvertently about 1st gear being rather soft.
Mike I discovered that the worm on my steering column appeared to be bent consequently I removed the worm to straighten the shaft. To refit the worm I made up a simple tool using some thick walled pipe with drilled and tapped holes at intervals to hold the steering column straight. Three tapped holes are required at each interval. One end of the pipe was sealed by welding a bit of plate over it. The top end of the steering shaft sits against this plate. At the other end a flange was welded to the pipe with three holes for threaded rod to pass through. A cover plate with three drilled holes to line up with the flange holes is also required. With the shaft fitted and the screws done up finger tight along the shaft the worm can be placed with the end plate and threaded rods to push the worm back in place. Carefully tighten the three rods progressively to drive the worm back into place.The whole process was a bit of overkill however I had to investigate everything.I also added a lipped seal at the top of the steering box which required some machining.
Terry
I checked the steering column runout in my lathe. It is less than 0.010" so I think that is good.
Tom
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

