Best I can do is post pics of my rebuilt rockers. They had new roller rocker needle bearings replaced along with the adjusting screws. My engine is still spread out on the shop bench....
 
 
Gary Parsons
I have rebuilt many set of rockers and there is no advantage using S/C rockers.
The lower bushing pushes out easy and the nos steel lined goes in easy as well.
If you use bronze which is an acceptable replacement the OD as well as the ID will have to be sizedThe OD will need to be cut down prior to pressing. If you use the needle roller bearing you will not need to drill the oil hole in the lower bushing. The oil vapor is plenty of lube and will increase oil pressure. Some modification roller pocket is required because the needle roller is wider.
Also the 3/8 hole for the pin will need to be bushed to 5/16. I have the bearings and pins and bronze bearings. This modification has been used for years and is by far the best to date
Tom we are just about ready to tackle this job too. I will be using bronze bushes.
The lube hole was drilled from outside for production.
If one hole is drilled in the bush the bush can be carefully pushed in to maintain the lube hole alignment. The bush would then be reamed to the finished size.
Thank you for your response. I have a set of needle rollers I believe I bought from you several years ago. I have finally gotten around to using them. That sounds like the best way to go.
Tom
Terry
I will probably go for the bronze bushings as well even though I have a set of steel ones. My shafts have been hard chromed.
Tom
Tom, I had my shafts hard chromed plated and ground also.
The guy who did the job pointed out that you cannot uses needle rollers on hard chrome as particles will flake off, but bronze bushes are ok.
just some clarity. needle rollers are used to replace the original rollers that ride on the cam. bushings ride on the chrome shaft
 
I recall this discussion earlier this year. I believe I was telling Terry this about his shaft restoration. Another member also mentioned this about hard chromed shafts should not see needle bearings because of the contact area of the needles damaging the hard chrome.
 
 
Gary Parsons
Gary
The new roller assemblies that ride on the cam are a self contained unit. The inner needle race is in the unit. The shaft that goes through them to hold them in the rocker arm should be a tight fit so that the roller assembly does not rotate on it.
There would not be room to fit a needle bearing in the rocker arm end that goes on the rocker arm shaft. I don't think the back and forth motion of the rocker arm on the shaft would be a good place for a needle bearing anyway.
Tom
Tom, Many high performance roller rockers have the rocker to valve contact where the actual roller is. This reduces the friction of the metal to metal contact. I did goof and post that our rollers are at the valve end. But as George mentioned and others. The actual shaft has the bushings. Then the needle bearing rollers are the cam to contact area. These camshaft n valve arrangement is very complex compared to most V 8 engines. Every cam bearing is different sizes. There are several different sizes of rocker spacers. Then getting the valves n springs into the block at the correct time is VERY important.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
