I recently dismantled my 810 engine to find that the main babbit bearings were starting to disintegrate. The big end bearings had been converted to shell bearings back in the 1950s. The crankshaft needs grinding plus the block needs re-sleeving and new pistons as it was plus 0.065" already. A bypass oil filtration system had been installed many years ago but it was not up to the job. When you study the oil circulation diagram in Cord Complete you will see the main bearing journels closest to the oil pump can get the most grit in the oil and wear the most which is exactly what had happened to my engine.
To minimise problems in the future I am going to convert the block to full flow oil filtration. This modification had been designed by Lee Richardson in the past. Consequently I will be able to have made and fitted new phosphor bronze main bearings. New shells will be fitted to the big ends as well. Babbit bearings were designed to absorb grit. Proper filtration is the key to preserving a rebuilt engine.
Charles I will have to check the bearing shells as there should be a number on them. I am in Australia. I am not sure if you need to do anything to your connecting rods. Contact Bill Bicknell, Roger Von Bergen or George Arakelian their email addresses are in the Directory. They should be able to point you in the right direction.
I think doing the full flow oil filtration modification could be a tricky job as there is a sloping surface to be drilled through to reach the oil gallery above the pump. I think a drill jig may be required to keep things aligned.
Hi Charles. Any chance of seeing a sketch of the drill jig you used ?
Thanks,
Terry
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
