Did you rebuild the wheel cylinders yourself from original units? If you bought them assembled, are you sure the right pistons were used? It seems to me the only thing that would keep them from going in far enough is a bound-up spring, the wrong pistons, or wrong pins.
CORDially Mike
CORDially Mike
I bought the car with a rebuilt brake system, but a known front grabbing brake. I didn't have time to work on it so I let it sit for a few weeks. When I tried to move it the left front brake was stuck and I had to back off the adjuster all the way to get it to move. When I pulled the drum the grease shield had not done it's job, and the shoes were not resting on the top centering pin. Evidently the grease had caused the lining to swell enough to lock the brake. Since I had not worked with the bendix system before I pulled the right front drum to see what it looked like. The shoes also did not rest on the top centering pin and there also was very little back off ability on the adjuster. One more, pulled the right rear, very little back off ability, but the shoes were sitting on the centering pin.
After trying to measure the length of the push pin that would let the fronts ride on the centering pin, I noticed that the one piston was sticking out about 1/4 inch when the push pin was removed and the other side was pushed up to the centering pin. I opened the bleed valve, took a large pair of water pump pliers and squeezed the piston back in the cylinder. Then got a shim and squeezed the piston in so that the original pin would fit. Put the spring back on and did the same thing to the left front.
Since the grease shields weren't workin well I am now trying to figure out what I have to make to straighten a conic surface. When a get 2 straight grease shields I will find out if I have solved the problem or need to do something else.
I really appreciate the comments and pics.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


