Dumb question: Does 810/812 Cord engine have a timing chain' date=' or is it a timing gear?[/quote']
These engines have a chain. The FB non supercharged engines use a 1 1/4 inch wide Whitney thain and the FC engine that has the supercharger will have the same maker chain but it will be 1 1/2 inches wide. they both use the 1/2 inch pitch chain. They are no longer made but. A GM chain will fit nicely out of a V8 engine around the same years. Also we can purchase a chain from a company I have on my records but can't recall the name right now. It fits ok but Henry told me it was a bit loose. Egge sells this chain too for around $200.00.
The lycombing cam has a thrust washer near the front of the cam. I really do not know why yours "welded itself" and broke the key in the cam. I suppose you have the cam gear removed. If so you may know these engines have an oil port hole in one of the front plugs. I do not reacll which of the three plugs it is but someone here will know before I can get back to you bout it.
On my engine someone replaced the cam bearings with aftermarket brass bearings. Two of them were a little too tight on the cam bearing journels and froze to the cam journel. then spun in the block.. No damage done to cam or block but I will be replacing ALL the bearings. Btw there are 5 bearings and every one of them are a different size diameter. I was told 660 brass can be used for a good bearing. OEM was a babbited bearing but are no longer available.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
