I have been told to avoid Coker by a person that knows. He runs Blackwall tires and they are radials. As to the exact brand hes runnjing I do not know. I may take me a few days to post what he runs. I will be running a whitewall because I believe they make the Cord look finished.
 
 
Gary Parsons
I have been running Diamondback whitewall radials on my Westchester for the last 3 years and I have been very happy with them. ┬áThe website is dbtires.com. ┬áThe tires that I have are the Auburn Deluxe Radial, size 650R16 with the 3 3/4ÔÇØ Extra Wide whitewall with the beauty bar. ┬áI will be putting a set on my phaeton as well once I finish installing a rebuilt transmission and reassembling the engine after rebuilding the supercharger.Bill
Hi Bill a local shop balanced my wheels with adhesive weights that are attached out of sight to the wheel rim.
Centrifugal force holds them in place. You don't see any weights around the hubcap just the painted rim and no damage to the paint.
I have been running Diamond Back radials, two sets, on my 35 Auburn and two 67 Corvettes for 18 years. Very happy with them.
CORDially Mike
Hi Hooter, I had two Coker radials blow out on my Cord at 75mph and another one go flat on the show field. Coker told be it was my fault because I was supposed to change the tubes every 2 years.  Needless to say I through out the tires.
 
I've run Diamond Back since then and been very happy.
Jim what is the overall width of these radials?
I have been using cross ply Firestones. These are wider than the original tyres, so I had to raise the trunk shelf 3/4" to place the spare wheel.
Changing the tubes every two years is a bit hard to swallow. Seems any excuse will do. The tubes have been in my Firestones for well over 12 years.
Hi Terry,
 
According to the Diamondback website the Auburn radials in the 650R16 size are 29.3 inches tall, 5.2 inch tread width and 7.3 inch section width.  You can find the table of tire sizes on the dbtires.com website.
 
I can tell you that the spare would not fit in the trunk (boot??) of my Westchester.  The tire is too wide to fit under the shelf or under the metal tire stop in the trunk.  This prevented the deck lid from closing with the tire installed.  I wound up cutting out the metal stop bar and leaving out the package shelf so that I could have the spare in the trunk.  You may not want to take these steps.
 
Best regards,
Bill
Terry,
The original tires on the Cord were 6.50 X 16. There tires had a width of 6.5", height of 5.85" and a diameter of 27.7"
Most of the radials I have seen are 225 65R16. These tires have a width of 8.85", Height of 5.75' and a diameter of 27.5"
So these radial are very close to original in height and diameter (so speedometer is close) but are 2.3" wider. This creates a problem with the spare, which others have noted (I put spacers under the package shelf and bent up the end of the front tire stop to get the spare to fit) and with the rear fenders. For the rear fenders adjust the support behind the wheel to kick out the fender a little bit for clearance. They work fine on the front wheels.
 
If anyone is interested I made up an excel spreadsheet of the original tire size and the actual tire size of different radials so you can compare the width, height and diameter to original. Send me an email at ob7879@outlook.com and I will send you the excel file.
 
Jim
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


