Make sure the kits are new. NOS kits are to old and won't stand up to Dot 5 if you decided to us that.
CORDially Mike
V
· May 19, 2025
Hi Mike. I was reading a recent post from Alan Cutler about his master cylinder leaking. We are trying to source a few new washers that are used to seal the master cylinder to the "end cap" where the outlet connection is located. I see that Alan also used a neoprene gasket and an extra washer to get the connection to seal. Any help on this would be appreciated. An additional question is if anyone knows if there is a person/company that can sleeve the master cylinder, as the inside of ours is scored and needs to be resurfaced.
M
· May 20, 2025
Apple Hydraulics. Do it stainless.
CORDially Mike
J
· May 21, 2025
Mike - Some of the new kits will nit stand up to DOT 5. If going to DOT 5 make sure the kit is rated for the DOT5 fluid.
V
· May 21, 2025
Thanks for the quick reply. Will check out Apple. Not going to DOT 5.
V
· May 21, 2025
Contacted Apple. Talked to "Bob". They can do the re-sleeve, new aluminum washer, and/or rebuild the whole assembly.
Thanks!!!
 
Vic
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.