Cord 810-12 lenses are right and left and they have to be shallow in the dome contour for the lids to close. I have a sealed beamed conversion that may be very old but works well. It uses VW 6volt bulbs. I was on a mission to restore the 1937 lights to factory specifications. I got very close but was missing one chrome lens retainer, I have all the other clips and springs, and reflectors with the parking lamp holes and bulbs. I have some old stock lenses, maybe Chrysler, very close, that are the correct diameter and I am thinking they are Chrysler. I gave up on this project twenty-five years ago in trying to go back to stock as I can't find the small trim stainless glass lens retaining ring that holds the bulb, I have one left side. I could dig all the parts I have out and send a picture of what I have, and what I am missing, there is just so much to do so it gets pushed back in my do-ist. I would like a stock connector to the bulb harness. I need a new fuel tank badly so that project gets priority.Back in the 1930s, it must have been a nightmare to keep working headlights when they were all different. not every service station would have a correct replacement lens and I cannot ever remember seeing any on the shelves in the fifties or sixties. After WWII the government mandated sealed beams for safety The Cord would have been one of the last cars with reflectors. I would bet many cars were scrapped because of non-working headlights and little things like burned points and holes in the inner tubes. I was going to add a relay to the headlight to help keep the headlight switch from arcing. I have the correct foglamps but may use a Trippe set like in the picture to cast an emergency beam in case the headlamp brows quit opening.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


.jpg.cf01351c75452ef9be3b59661688dc1b.webp)