Pat,
I checked with the local NAPA today trying to get rebuild kits for my 810. They had them listed, but they were out of stock and could not be ordered. Didn't ask about 812 kits .
You should be able to buy the wheel cylinder rubbers separately. From memory the sizes are 1" and 1 1/4" diameter. The first set I bought here in Australia did not have a defined sharp edge but had a round moulding near the edge. These leaked and were not suitable. I was able to find rubbers with a well defined sharp edge as per the originals which worked properly and did not leak.
See the attached sketch.
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Terry's post is right on. I just had my brakes worked on and the cylinders kept leaking until I passed Terry's drawing on to my mechanic.
Bill
Lockheed wheel cylinder cups :
Front 1 3/8" , FC-857, 1" FC-1499.
Rear 1 1/4" FC-666, 1 "FC-1499.
Lockheed also supplied expander cups.
Reference Wagner catalog 1944.
Thanks very much George for the cup part numbers and the dimensions I will pass this one. It sure will help.
 
 
Gary Parsons.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

.jpg.4cae3ca0f72a64060fd76d8bcb1b41be.webp)