Thanks for the rivet advise. I will be using Stainless steel rivets because I figured long ago this will work better. The large post that holds the brush arm in the end plate is made by me also. It has taken lots of engineering to do so too.
 
 
Gary Parsons
I'm not sure SS rivets are the best way to go. The diference in thermal expansion may come back to bite you.
Jim, My dissection shows rivets holding the brushes to the brush plate. The actual pins the brush arms rides on is a bit different but it too is a kind of rivet. This has been an interesting engineering adventure. The material called Invar has no thermal expansion caricature but its difficult to find or work with.
 
 
Gary Parsons
Exactly where are these pieces of Invar in every Cord car? My first contact with Invar was in 2005. It was being used as a form for a top secret F23 flighter plane mold for the top side of the body and wing. It never came to be a flyable plane.
 
 
Gary Parsons
Check out the invar struts in the pistons.
 
Thanks Pete. All I could think about where the Invar was located was in the suspension system somewhere. Never once thought about the pistons. Good call.
 
 
Gary Parsons
Pete, They had left overs from the fighter plane that didn't get built so the used them in the pistons.
CORDially MIke
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
