Gary it definitely is a very early gearbox case and probably from a Hand Built Cord. It does not have the Interlock hole that you mentioned on the RHS . Also it has an extra bolt on the LHS to hold the reverse idler shaft in place.
Attached is a page from Bill Bicknell's detailed article on hand Built Cords that can be found in The Reunion Book, No 2.
I have no idea why the picture ended up on it's side.
 
this is a listing for a three bolt carburetor intake, the photo from the hand built case shows a similar intake, it would be nice to see a list of the different parts used in the hand build's, are the thermostat housings cast iron?
https://www.ebay.com/itm/333562965039?hash=item4da9e6ec2f:g:2gQAAOSweqdebX4H
In my previous email I made reference tp the detailed article on Hand Built Cords in The Reunion Book No 2 that was printed in 2010 by the ACD Club and which can be purchased from the Museum in Auburn.In the article the variations are all listed.Attached is a copy of that complete article by Bill Bicknell. .jpg.7296fc80300be2817094192da308e1d5.webp)
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

.jpg.d81f1bfd669bc3b9cf4563a2e6633df1.webp)
.jpg.ab76ac942d712925dc852997159d6d82.webp)
.jpg.fdbf8583305dde5fec954ee3e8f99006.webp)
.jpg.11f33d30a7a3f96a0462585449bc1196.webp)
.jpg.d207a22342c1399a94022be22bcdf67b.webp)
.jpg.d27635462fcfa62058d1df2a543f152f.webp)
.jpg.0e8898a630487cd814ca240e6bc4e10f.webp)
.jpg.a77b12a0862551dbf6d86e8899576c50.webp)







