Don't know about Cords but other cars have drain holes in cowl vent area with tubes to take the water some where besides on your lap.
CORDiallyMike
On my car the holes are for the windshield frame mounting bolts. The holes are about 1" in diameter and are very crudely cut. Some look like they were cut with a grinder. The factory obviously did not use a template to get the exact location for the bolts. As a result large washers must be used under the holes to mount the windshield frame.
Thomas
These holes appear to be punched or drilled out. They are ONLY across the bottom of the windshield opening. They are about 1/2 inch diameter. I will post a picture of them later today.
 
 
Gary Parsons
My car is a phaeton which I just learned is entirely different in the windshield area.
regards
Thomas
The hole in the windshield area Gary is refering to is so when you open the windshield the car whistles as it goes down the road. If the Cord is happy it whistles a nice tune, if the Cord is not happy it is very annoying.
 
I'm sure some of you have experienced this!
I thought the holes were evenly spread out to make sure the water that comes through around the seal was evenly spread out so there was no dry spot for your legs and feet.
Pete
Terry
"Why didn't they drill holes in the floor to let the water out? "
Your point is well taken
Pete the answer is obvious, they were is such a hurry to get them out the Factory door they just forgot. When you get wet feet driving a Cord it just makes you remember what a fabulous car that you are driving.
Besides Jim O'Brien's trick of running a silicone bead around the seal area solves the problem. I rode motorcycles in the rain for years, got wet feet too and kept going back.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


