Gary; What you have is a reprint from The National Automotive Shop Manual, published by the late Bill Kinsman of Buffalo NY. The " Forward" indicates is of general information, a supplement to the Factory Service Bulletins. On page 10
the description reads; " an electric heating coil within the choke case , and controlled by the ignition switch -------" Not so on the Cord. See the Cord wiring diagram , it shows a 16 gauge brown wire connected to the generator armature. This question came up in a previous blog. I just wanted to clarify this.
Thanks George. The wiring is as you posted. I recall others asking if this was the correct way to wire from generator directly to the electric coil. In the booklet on page 10 the diagram on the left shows both manual and electric choke hooked up on the same carburator. This is the piece I can't explain. Many posters about this have mentioned this was never done this way. This picture of the manual and electric connected together shows how the system works by overcoming the electric side if needed.
 
 
Gary Parsons
Hi Gary, I too have a copy of the book. At "first glance" yes, it looks like the automatic choke and manual choke mechanism can both be fitted together.
The drawings showing the manual and automatic choke are on page 10.
On page 8 under the heading CHOKE, EE-15, EE-25
It says, The "Triple Range" hand choke control is not used on Cord.
Consequently looking at the drawings again, for reasons unknow they show both controls together. It is a case of either the manual choke or the automatic choke but not both together.
From what documentation we do have it appears the EE-15 was only fitted with an automatic choke. There was no hole in my firewall for a choke cable.
Gary what we have in print says only the automatic choke was originally fitted to our Cords. In the Cord Service Manual, Bulletin No 21 dated May 20, 1937
The procedure is given for fitting a manual choke to the 812 supercharged carburettor.
Item 2 says "Remove automatic choke mounting bracket."
Item 7 says "Using new choke shaft reassemble ................."
Item 9 says "Drill dash for choke control cable ..............."
The pictures you found are interesting but it looks like somebody had fitted a Lasalle carburettor as suggested by EL.
Terry, George knows plenty about the Cord oddities...... I find it fascinating doing my research. And then have someone with much more knowledge clearly explain a picture from the internet searches I do. But my finding what appears to prove what I believed to be correct... But was not. I will NOT be setting up my carb with both manual and electric choke.But for now it will be manual. I never had the electric choke on any of my carbs. Our Cord was purchased in 1961 and who knows what the previous owners did to keep it on the road. BTW our car came off the road in 1949 from all the documents I have.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


