Hi,
Yes, such type of problm will happen, check your program again
Just a question
Is the rubber in the rear motor mounts too tall or just not loaded with the weight of the motor?
Pete
Thanks everyone for the suggestions and help. The frame mounted horns can't be reversed as Pete has shown. I don't believe the block mounted can be switched from side to side. It surely can't be flipped over and bolted to the block. The bottom two bolt holes have a very slight bend in the plate to match the block.
What fixed this mounting issue was removing the horns at the frame rails. then mounting to the block. then bedding everything down to the frame. It was that simple. Thanks Mark Clatin for the suggestion.
Many years ago everything was removed from the stub frame and professionally stripped. Then I primed it and painted it black. Then I installed the mounts. Never would I have guessed the slight amount of placement was going to be an issue. But it sure was. But now everyone doing the work I have can learn something.
Cliff... I looked closely at the modern bell housing hole. Your correct. It was made by someone but no idea why. Being cast iron it will be difficult to repair so am probably going to leave it as it is. If the next caretaker feels it needs to be repaired or replaced so be it. For now its not that big a deal for me.
 
 
Gary Parsons
John, I searched my files and found this information from Stan detailing the motor mounts and brackets placement. It does not appear switching or flipping the brackets that mounts to the block will harm anything but the horns that mounts to the frame are side specific by the part numbers and the cut to follow the frame.
 
 
Gary the way the block is connected to the chain is of concern to me. My I suggest using a stout rope fed under the block? See my attached picture.
In another posting we saw how the engine was being lifted from Moonshadow with chains wrapped around the exhaust manifolds. A bit more care can avoid a disaster 
Thanks for the suggestion and pictures Terry. My trans and engine are mt.No parts are inside them. Are you thinking I put too much stress on those head bolt threads or where I placed the lifting area? I suppose I could have lifted from the center or bottom wow of head bolts too. Using chain gives me an exact lift where webbed type slings or rope has some give or stretch to it. My plan is when I install a dressed engine and trans is to make lifting pads to bolt directly to the top of the trans and the block where the intake manifold bolts down. I have seen so many big and small block chevy engines being lifted by the intake manifold bolts using a special plate. Am not in favor of that...
Sorry Terry. I believe I see what you are concerned about. I removed the other chain I had from the hook to the edge of the trans differential flange. So my picture appeared to be only lifting from the block. Not a triangle type lift as I had done. But for sure I balanced my lift by adjusting the chain length so I had a level lift. When I learned how to level a steam turbine rotor or shell we used a special Starratt level on the lift. We had to make the lifts within 8 thousands per inch of length of shell or shaft. Our running clearance was usually 15 thousands before the seals rubbed.
 
 
Gary Parsons
Gary you could fill that hole with a variety of filler materials even body filler.
I believe Pebble Beach cars have had body filler applied to the engine block to give a good smooth "show" finish. Just make sure the sides of the hole are clean and have a rough surface for the filler to hold onto.
Epoxy would be another choice. Maybe incorporate a little "rebar" to give it more strength.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





