I cur rhe shaft back where Im pointing and install 2 seals that seal transmission oil from traveling down the main transmission shaft and get onto the clutch.
G
· May 16, 2020
Gary I found JK Howell's directions. 1. Remove release bearing guide and remove 1/4" to 9/32" from face 2. reinstall guide. 3. install two seals into hole in clutch housing , in front of guide. lips facing transmission. Grease sealing lips and use care when installing transmission.
1
· May 16, 2020
Thanks George. This clear explanation sure helps. Its answers like this that makes our cars seem simple.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.