Gary, those switch circuit boards were a thermoset - bakelite - phenolic as JMM says - type of plastic, and very much like the old Formica tabletop/countertop material. If you can find any of that, try putting heat to it with a soldering iron and see if it doesn't hold up just fine. You can probably find some of that hardboard at electronics shops - used for electronic breadboarding, as we used to call circuit designing - putting transistors/resistors/diodes onto a board and soldering them all together. Actually, just try to find modern fiberglass-like circuit board material for making printed circuits, but without copper on both sides if such a thing exists.
And if you can solder all those brass buttons/rivets versus just clinching them, you'll avoid having the brass tarnish/oxidize with age. The oxidation begins making every clinched/riveted joint a slowbuilding resistor, increasing the heat of each joint when juice is flowing, and can eventually lead to burnthru of the parts. I know as I imported a 1953 Panhard X87 break which had been garaged in 1969 and left there until 2006 - 37 yrs - due to burnthru of a complex brass-riveted-together master control switch on the steer. column. The switch is so complex that everyone back then gave up on trying to fix it and parked it. Let us know what you find - there may be other uses for the stuff -
Ken
Here's Mcmaster Carr's stock of insulating circuit board materials:
https://www.mcmaster.com/insulating-circuit-boards
Ken
And more high temp circuit board materials:
https://www.mcmaster.com/insulating-circuit-boards/arc-resistant-gpo3-fiberglass-sheets-and-strips/
Ken
I'm pleased to know someone else is rebuilding and making these switches better than original.My investigation shows these headlight switches were suspect from the get go. My 37 has been converted to sealed beam long before my Dad got the car in 1961.Records show the car came off the road in 1949.
 
 
Gary Parsons
not exact with a few flat metal tabs it should work as well and no-one sees under the quadrant.
https://www.ebay.com/itm/Cord-1936-1937-812-810-Headlight-switch-NOS/143980171628
see this modified switch
I was told to protect the headlight relay as the amperage is high for the switch, especially with two sealed lights. This would require additional feet of non original wire runs for the two relay setup. They lamps are energized for many hours causing breakdown of the terminals causing dim headlights. My main purpose of me using a relay is to protect the original switch. I have seen two relays recommended but I was advised one is fine,
https://www.facebook.com/photo/?fbid=10159266839043979&set=pcb.10159266839598979
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
