Hi Gary,
I think that you meant that the negative side of the battery goes to the Startix, if it was the positive side no electricity would flow since that is grounded. The ground strap from the stub frame to the transmission case just helps to get a good ground on the drive unit/motor assembly as the motor mounts can sometimes prevent a good ground as they are rubber. Since electricity prefers the path of least resistance the electrons will travel through the drive unit case and engine block because that is much easier than trying to travel through the ball bearings / race connection. No harm should come to the drive unit.
Rest easy but keep thinking deeply.
Best regards,
Bill Kastanis
1937 812 SC Phaeton
Thanks Bill and Terry for answering my concerns. Terry I had planned to add a strap from the starter to probably the frame rail so the flow of least resistance is shorter and a much more direct path from the battery. If I ever get to Auburn of course I would remove it. Bill, I'm always thinking deeply bout many things...
 
 
Gary Parsons
The current won┬┤t do any harm to the bearings inside the transmission, it will run on the outside like on the cage of faraday.
To place a second ground wire is a good idea, cause if the only ground wire breaks, the current will search a new way when the starter is engaged, and this way may be through the temperatur gauge or some small shifting wires and that will do final destruction to these.
electrical regards from Nuernberg in Germany where Georg Simon Ohm discovered the elemantary law of electricity!
Terry, The recommendation for running a ground cable (it should be 00 cable) from the battery to the starter mounting bolt is an old one. The ground circuit from the battery to the frame under the seat, to the stub frame, to the engine/transmission to the starter. After 80+ years corrosion has crept in and it doesn't take very much resistance to prevent the starter from working as it should. If you are doing a full restoration pull the stub frame and clean the connection between the stub frame and the body frame as well as all the other connections including starter, grounding straps, transmission to bell housing to engine, etc. When you get done measure the resistance from the battery to the starter. It should be as close to zero as possible (I've had cars with 2 ohms not work).
 
For older drivers run the ground cable to the starter.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
