My experience has been if you have a original, a machine shop can do a punch test to determine the Rockwell hardness and heat treat to those specs.
CORDiallyMike
Thanks Mike. Somebody has been inside this trans before me. When I opened it I found a new lower cluster gear with a 1936 date from DGW..Detroit Gear Works. I found the second third gear synchro was missing all the balls and springs plus the second synchro clutch was missing about 25% of it. This "repair" was done sometime between 1949 and 1961 before Dad purchased the car. Also the oil pump had been partically rebuilt with new gear and shaft. But only the body was machined for the drive bushing but nothing was installed. So the drive gear was flopping around in the huge body hole.Not good at all.. The splined thrust washer had been inlarged from 1/4 inch to 5/16 inch too. So not knowing the correct size or thickness or hardness is where I am now.. But its learning that counts...
 
 
Gary Parsons
Mike - Dong the "punch test" will only tell you the surface hardness. You have to determine the depth of the hardness. If the thrust washer or gear is hardened all the way thru it will be brittle and won't hold up. If it is just case hardened(on the surface) you will wear thru the hardened surface quickly and then wear out the gears quickly. There is a considerable amount of engineering and design that goes into hardening a piece of metal.
 
Gary - the gears and thrust washers are available. Get them from a reliable source rather then reinventing the wheel. Most of the people that have tried to reverse engineer these parts have screwed them up and done a lot more damage. Also the the gears are marked DG&M - Detroit Gear and Machine
Thank you Jim for the very sound advice. As for gears... I purchased the needed gears from George Arakelian. One was from George Van Nostrand. I do not believe I need any other gears. Its just the thrust washers needed. As I have said in the past. I have no idea who or when someone was in this trans but some parts were missing. Time to buy some thrust washers and finish my trans repairs correctly.
 
 
Gary Parsons
I definitely bow to Jim's expertise. That's what this forum is all about.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
